In the 1970s and 1980s, Shanghai's reducer technology had made great developments and was closely integrated with the development of the new technological revolution. There are more and more users of Shanghai speed reducers , but few people will pay attention to some precautions in the use of Shanghai speed reducers , but use them blindly, so that the service life of Shanghai speed reducers is greatly shortened. In this chapter, I will introduce three points for you to use the Shanghai reducer:
1. It is strictly forbidden to hammer the reducer's output shaft with a coupling, coupling, pulley, sprocket and other couplings. Direct hammering is not allowed. Because the output shaft structure of the reducer cannot withstand axial hammering, the shaft can be used. Screw in the end screw hole and press into the joint.
2.Be sure to install a vent cap (exhaust plug)
Before use, replace the block at the highest position with an exhaust screw plug to ensure that the body exhausts gas when the reducer is running. If it is not replaced in time, the reducer will run for a long time, which will cause the gas in the reducer to swell the oil seal and cause the reducer to leak oil.
3. Change the lubricating oil in time, paying special attention to the first time.
Special attention should be paid to the first oil change. After the first operation of the reducer for 300 to 400 hours, the lubricant should be replaced in time. After that, the oil should be replaced every 1500 to 2000 hours. In addition, in a harsh working environment, high temperature, and dusty workplaces, the lubricant should be checked every half a month. If there is dirt on the lubricant, replace the lubricant to keep the lubricant clean and extend the use of the reducer. Life and improve economic efficiency.
The above are the matters needing attention in the use of Shanghai reducer . I hope to attract the attention of those who have not paid attention to the use of the reducer, so that the Shanghai reducer can have a relatively long service life.
|China's helical gear reducer industry should establish three major systems|
|Three tips for safe installation of stepless speed reducer?|
|Five Tips for Gear Steering Boxes|
|Four major reasons for oil leaks in Shanghai reducers|